For what it's worth - my two cents:

Geht man von Laborbedingungen aus und betrachtet nur die Kraft die nötig ist damit der Verschluss versagt, braucht sich der Axis-Lock vor einem Frame-Lock nicht zu verstecken, ganz und gar nicht.

Das "Problem" mit dem Axis-Lock ist einfach das er "im Feld" schwer bis nicht zu reparieren ist, schon relativ wenig Schmutz, Matsch etc. reicht um kein vernünftiges Lock-Up mehr zu erreichen, bzw. das Messer geht gar nicht erst auf, weil sich auch dafür der Bolzen des Axis-Lock bewegen muss - ist da zuviel Dreck etc. im Spiel, geht das nicht.

Von daher ist ein zugänglicher Frame-Lock absolut überlegen, insbesondere in dieser offenen, minimalistischen Bauweise die Strider verwendet - da reicht ein kleines Stöckchen zum sauber machen - und auf geht es unter allen Bedingungen.

Strider treibt das ganze noch etwas weiter, schaut man sich die Ausfräsungen im Griffbereich des Lockbar an, die sind aussen, und nicht wie deutlich verbreiteter, innen. Damit wird die Kraft die von der Klingenwurzel auf den Lockbar übertragen wird und in den Griff geht, in einer Linie übertragen, das verhindert zusätzlich bei Schock-Belastung das der Lockbar "springt" und die Klinge freigibt.

Hier mal was vom Macher selbst dazu:


21. Why is the lockbar cutout on the outside of the Ti instead of the inside?

Per Mick Strider: "If you think about the geometry of the knife, and the lock in particular, you will notice that the line of the stress caused by the lock interacting with the blade runs in a (mostly straight) line from the back of the blade down the lock and into the ti side handle.

If the cut was on the inside, the stress would run down the lock bar until it reached the cut, then it would transfer over to the other side of the lockbar…and cause the bar to flex and pop off the blade, rather than transfer the energy down into the rest of the handle.

22. Why does only the lower section of the lock bar contact the blade on Strider Folders?

Per Mick Strider: "The reason we only want contact at the lower section of the lock bar is this:

1. For the most solid lock, you need two points of contact, as far apart as possible. (bump stop and lock face)

2. For the most solid lock, your lock contact should be as far away from the center line of the pivot as possible. This keeps your lock from "rolling" off the blade.

3. No matter how far from the pivot center your lock surface is, if its contaminated with crap (sand), it will fail. We send knives into some nasty shit. This is a huge concern for us. By making contact at the lowest section only, it creates a "shit vent" above the lock surface. That is the same reason we make our detent hole go all the way through the blade....its a "shit vent"."
Viele Grüße,
Oliver